|
FLEXIBLE ENERGY PRE-SET
|
| Forming energy can be adjusted easily and flexibly by the setting dial. At each stroke, energy level has higher stability by the sensor feedback system. |
|
SKILL-LESS EASY OPERATION
|
| By the electro-pneumatic operation system, even unskilled operator can use this machine within short period. |
|
SAFETY
|
Spring engaged, pneumatically acting brake device is installed. Emergency stop is ensured at any time.
The design of this machine is based on the Japanese press machine standards of safety. |
|
REPEATING 3 DIFFERENT POWER
|
1st, 2nd and 3rd pressing can be automatically repeated.
Each pressing energy is adjusted individually. |
|
HAMMERING MODE
|
During Ram ascent period, next quick pressing can be made by pushing the switch again and again.
Automatic mode can be selected by the pre-set of next pressing start timing. |
|
|
|
EJECTOR AND CUSHION（OPTIONAL）
|
| Ejector for both lower and upper mold can be equipped. Cushion is also equipped in order to take out the formed material at upper or lower mold every time each side. |
|
OVERLOAD PROTECT LOADGAUGE （OPTIONAL）
|
Each pressing power can be aware on the digital readout.
In case of the overload, press can not continue to operate except power resetting. |
|
AUTOMATIC SYSTEM（OPTIONAL）
|
| Automatic handling sysytem with robot hand or loading unloading device etc. can be equipped. |
|
HIGH EFFICIENCY FOR VARIOUS
SHORT-RUN JOBS
|
| By the absence of bottom dead point, quick die setting and easy trial could be carried out. |
|
|
